BOOTH No. 125Date: 30TH AUG ~ 1ST SEPT 2018 Address: Tokyo International Exhibition Center West Halls 2, West Exhibition Hall, Tokyo Big Site 3-11-1 Ariake, Koto-ku, TokyoContact Person: Kelly ZhangPhone: +86-13066182261Email: Kelly@pmma.hk

Acrylic (plexiglass) is widely used, and it can be seen on aviation equipment. However, like many other polymer materials, it is eroded by moisture in the air, which causes certain aging of plexiglass sheets. It has a certain influence on the performance of the board.
The test shows that the water c

The fluidity of PMMA plates is worse than PS and ABS. Melt viscosity is sensitive to temperature changes. During the forming process, the melt viscosity is mainly affected by the injection temperature. Polymethyl methacrylate is an amorphous polymer having a melting temperature of more than 160 ° C

Acrylic cast-in-place board, as its name implies, melts the acrylic material at a high temperature and deposits it in a mold. Due to the high molecular mass produced, it has excellent stiffness, transparency, and excellent chemical resistance. Acrylic cast sheets have very good transparency, and the